1- محل انتخاب شده بر روی لوله آبرسان جهت تزریق کلر باید به گونه ای باشد که از آلودگی آبتصفیه شده جلوگیری نماید و قبل از مخزن هوایی ذخیره آب باشد تا زمان مانده لازم برای تماس آب و کلر ، که مهمترین عامل موثر در گندزدایی آب به کمک کلر است ، فراهم شود .
2- خطوط تغذیه تا خط آبرسان باید تا حد امکان کوتاه ، از جنس مقاوم و با دوام باشد ، به سادگی قابل تمیز کردن و بازدید و در دسترس باشد ، در زمستان یخ نزند رسوب انتقال گاز کلر به رنگ زرد باشد در صورتی که درمحل اتصالات و اطراف سوپاپها و انژکتور دستگاه روسباتی مشاهده گردید ، بایستی اجزای انها باز شود و با محلول رقیق اسید کلریدریک و یا سرکه شستشو شود .
3- پمپ تزریق کلر نباید بیش از 2 متر مکش و 10 متر تزریق نماید .
4- پمپ تزریق باید در محل نصب کاملاً تراز و محکم باشد .
5- محل نصب قسمت تزریق کننده به خط آبرسانی باید پایینتر از خط مصرف باشد در غیر اینصورتممکن است به علت ایجاد حالت سیفون ، کلر مازاد بر نیاز وارد خط شود .
6- معمولاً چون انژکتور با دو عدد ساچمه کنترل می شود ، بایستی الزاماً زیر لوله خط آبرسانی یا مصرف نصب گردد .
7- محور لوله آب ، نقطه مناسبی برای تزریق کلر است .
8- در صورتی که فاصله محل نصب پمپ تا خط مصرف بیش از یک متر است ، حتماً از لوله با قطر حداقل یک اینچ استفاده شود ، تا فشار معکوس سبب آسیب دیافراگم بگردد . در این صورت افت فشار حین تزریق نیز کاسته خواهد شد البته در صورت استفاده از اینگونه لوله ها احتمال انسداد بیشتر بوده و لازم است زود به زود عملیات شستشوی لوله ها انجام شود .
9- جهت راه اندازی پمپ تزریق درجه تنظیم دبی روی حداکثر گذاشته شود و پس از جریان یافتن محلول کلر در لوله خروجی تنظیم ، روی درجه لازم تنظیم شود . درجه تنظیم را وقتیکه پمپ در حال کارکردن باشد ، باید چرخاند در غیر اینصورت به آن آسیب می رسد .
10- فاصله سوپاپ مکش تا کف مخزن ذخیره محلول کلر باید حداقل 25 سانتی متر باشد تا از ورود رسوبات کف مخزن به داخل سیستم جلوگیری شود .
11- در مواقع لزوم با کمک اسید کلریدریک رقیق (20 -%25% ) می توان اتصالات را از جرمها و …شستشو داد .
12- بکارگیری یک عدد شیر یکطرفه برای جلوگیری از پاره شدن دیافراگم در مواقعی که افت فشار خیلی زیاد است ، ضروری است .
13- نیازی به نوار تفلون برای آب بندی اتصالات اصلی دستگاه کلرزنی نیست چون با واشر و اتصالات با فشار دست و بدون کاربرد آچار انجام شود تا از شکستگی اتصالات با فشار دست و بدون کاربرد آچار انجام شود تا از شکستگی اتصالات جلوگیری گردد.
14- شیربرداشت آب با مخزن اختلاط فاصله کمی داشته باشد .
15- باید جایگزینی مخازن اختلاط و ذخیره کلر به گونه ای باشد که محلول کلر به طور ثقلی و بهراحتی به داخل مخزن دوم یا مخزن ذخیره منتقل شود . لازم است مخازن فوق درپوش دار باشند واگر سطح مایع داخل آنها مشخص است ،بهتر است درجه بندی برحسب حجمهای مختلف روی آن انجام شود .
16- محلول کلر حین تزریق نباید با مواد دیگری مخلوط شود .
17- اگر تغذیه از چند مسیر انجام شود ، از برگشت مواد از مسیرهای فرعی به انشعاب اصلی ممانعت شود .
8- می بایست حداکثر اختلاط آب و هیپوکلریت کلسیم که توسط مخلوط کننده با سرعت 700-900 دور در دقیقه به هم زده می شوند ، انجام شود تا کلر فعال آن تا بالاترین حد آزاد شود و تلفات کلر همراه لجن به حداقل برسد .
19- در کل باید بهره برداری و کلرزنی به گونه ای انجام شود که حداکثر راندمان در گندزدایی آب حاصل شود .
20- با توجه به اینکه غالب هیپوکلریناتورها در کنار چاههای آب نصب می شوند ، بهتر است برق آب چاه و پمپ تزریق کلر به گونه ای به هم وصل شوند تا در زمانهایی که طی شبانه روز عملیات پمپاژ با کنترل اتوماتیک یا دستی انجام می شود ، عملیات تزریق محلول کلر آماده از مخزن دوم نیز به مقدار لازم انجام شود و در نتیجه نیازی به وجود اپراتور مقیم و دائمی برای دستگاه نخواهیم داشت ؛
در غیر این صورت بطور مرتب می بایست بنا به نیاز یک نفر بهره بردار دستگاه و پمپ تزریق را در ساعات مختلف روز روشن و خاموش نماید .
21- باید به مخلوط کلر و آب بعد از اختلاط فرصت داده شود تا لجن حاصل ته نشین و سپس محلول کلر صاف شده را جهت ذخیره برای تزریق داخل مخزن دوم وارد نمود .
22- به هر دلیلی اگر هیپوکلریناتورها بیش از چند ساعت از سرویس دهی خارج شوند ، قبل از شروع تزریق مجدد محلول کلر مسیر تزریق و رانش لوله اصلی آب میبایست با پمپاژ آب خالی شستشو شود .
23- با تامین دستکش پلاستیکی پیمانه مناسب ، ماسک ، پیش بند ، لباس کار ، عینک مناسب یا ماسک مخصوص مواد و وسیله شستشوی چشم باید ایمنی شخص بهره برداری کننده تامین شود .
1. Select a location on the water pipe to inject chlorine should be such that water pollution
Refined prevent air and water storage tank prior to the time remaining for the call
Water and chlorine, the most important factor for water disinfection with chlorine is provided.
2. The supply lines and water lines should be as brief as possible, the material is strong and durable, easy to
Very clean and is available online and in the winter freeze-yellow sediments, chlorine gas
If the connection is in place around the valve and injector device Rvsbaty was observed,
Components should be opened and washed with dilute solution of hydrochloric acid or vinegar.
3. The chlorine injection pump suction should not exceed 2 meters and 10 meters of the injection.
4. The pump must be installed perfectly level and firmly.
5. The location of the injection water line should be lower than otherwise use the
May cause flushing mode, Keller entered is surplus to requirements.
6. Usually, the injectors are controlled by two bullets, one must necessarily be below the water line or pipe
Application to be installed.
7. the water, suitable for chlorine injection point.
8. If the distance from the pump to the consumer over a meter is installed, make sure the pipe diameter
At least one inch is used to reverse the damage diaphragm pressure to look. The drop
Pressure will be reduced during the injection of the use of these tubes Plugging
More and should be done regularly washing pipes.
9. To start the pump flow rate setting and then set the maximum flow
Chlorine solution in the tube output, the degree of adjustment required. When setting up the pump
The work should be rotated, otherwise it will be damaged.
Distance to the bottom of the storage tank 10. The intake valves chlorine solution
You must be at least 25 cm of entry
Tank bottom sediments into the system to prevent.
11. when necessary with dilute hydrochloric acid (20 -% 25%) would be fitting to the masses and …
Cleaned.
12. The application of a number of one-way valves to prevent rupture of the diaphragm when the pressure drop
There is necessary.
13. The need to Teflon gasket for sealing joints and connections because the main Drumsticks
Hand pressure applied to a broken connections without the use of a wrench with hand pressure and without the use of screwdrivers
Be taken to prevent breakage connections.
14. Shyrbrdasht water mixing tank is within walking distance.
15. The mixing and storage tanks to replace chlorine as a chlorine solution to gravity and the
Easily be transferred into a second tank or storage tank. These tanks are necessary stopper
If the fluid level is determined, it is graded on the basis of different volumes
Be done.
16. chlorine solution during injection should not be mixed with other materials.
17. If a path is fed from the back of the alternate routes to prevent branches
Be.
18. It must be made by mixing water and calcium hypochlorite at 700-900
RPM stirred be done to ensure that the highest levels of free active chlorine and chlorine losses
With sludge minimized.
19. The whole operation should be done in a way that maximizes the efficiency of chlorination in water disinfection
Be achieved.
20. Since the dominant hypochlorinator beside water wells are installed, it is best to water mains
Well as chlorine injection pump connected to the day when the pumping operation
With automatic or manual control, the operation is ready to inject chlorine solution from the second reservoir
The amount needed to be done and there is a need for the machine operator will not have permanent resident;
Otherwise regularly have the need for a pump operator and the machine
Different times of the day off.
21. The mixture of chlorine and water after mixing should be allowed to settle and then dissolved sludge
Claire flat to store for injection into the second tank.
22. If for any reason hypochlorinator be out of service for more than a few hours before the start
Injected chlorine solution injection route and drive the main water pipe had to pump water rinse empty
Be.
23. The provision of appropriate gauge plastic gloves, masks, aprons, overalls, goggles or appropriate
Method and device for washing the eye mask must provide for the safety of the operation.
aqua tek Water Purifier, Water Purifier Crystal, domestic and industrial water purifier filter cutoff hot pot, hot pot second hand, steel hot pot, hot pot directly, Radiator water boilers, steam boilers and pressure vessels, water softener is , softener is designed boilers, boiler capacity, boiler sales, specifications boilers, boiler maintenance
